Rack PDU Basics: Metered vs Switched
Last reviewed: . Free reference — no quote or form needed. Methods and limits are stated on this page.
This page explains networking terms and how to check compatibility. It does not certify that a specific module or product will work in a specific host — the host manufacturer’s supported list and the exact datasheet decide that.
Short answer: a rack power distribution unit (PDU) is the power strip of a server rack, built for racks. The four common categories differ in what they tell you and what they let you do: basic PDUs only distribute power; metered PDUs add a local load display; monitored PDUs report measurements over the network; switched PDUs additionally let you turn individual outlets on and off remotely. Choose by whether you need visibility, remote reporting, or remote control — in that order.
The four categories
Manufacturer documentation (for example Tripp Lite's PDU selection white paper) describes the same four-way split: basic, metered, monitored and switched. Category names and exactly which measurements or controls are included vary by manufacturer and model, so check the exact datasheet. In plain terms:
- Basic: outlets and a breaker. No measurement. Fine where loads are known, small and someone is on site.
- Metered: a display of current draw, so you can see how close the unit is to its limit before adding equipment. Read-only: you can see the load, you cannot control outlets.
- Monitored: measurements available over the network, useful for spotting a growing load or a dead device from elsewhere.
- Switched: per-outlet remote on/off as well as monitoring, mainly used to power-cycle a hung device without visiting the rack, and to sequence start-up after an outage.
Sizing without folklore
Add up the actual watts of what will be plugged in (labels state maximums; measured draw is usually lower), and keep the total within the PDU and circuit rating with headroom for start-up. This page deliberately states no universal percentage rule, because continuous-load rules and derating requirements come from your local electrical code and the equipment documentation, not from a web page. If in doubt, a licensed electrician sizes the circuit; this page gives no wiring instructions.
Where PDUs meet the rest of this reference set
Network modules are covered in SFP vs SFP+ vs SFP28 and the optical transceiver guide. For turning watts and hours into energy cost for a small rack or home lab, the appliance running-cost calculator works for rack loads too — enter your measured watts, hours and your own tariff.
Sources
- Top 8 Considerations for Choosing the Right PDU (basic, metered, monitored, switched categories) — Tripp Lite (manufacturer white paper, Newark mirror). Accessed 2026-11-16.
Numbers on this page are worked examples from the stated assumptions, not tests of any product. Always check your own equipment labels and manuals.